DETECTORS OF OVERSPEED
All these detectors are available with the following options:
1 or 2 electrical contacts
type of connection to be defined (Jaeger socket or cable gland, or other on request)
low speed option depending on the type of detector and the desired speed.
R7 AIR detector
AIR type centrifugal reset detector: fitted with a 40Bar or 7Bar Air block.
Documentation R7 Air in PDF format
Detector R7 HYC
Centrifugal reset detector fitted with a 2 or 3-way NO or NC hydraulic block.
Documentation R7 HYC in PDF format
Detector NDR7 HYC or EL
Resettable NDR7 sensor: fitted with HYC2 or HYC3 hydraulic block (2- or 3-way) or EL position sensor.
Documentation NDR7 HYC or EL in PDF format
C1 detector
Centrifugal detector for precise detection of a pre-determined rotational speed, either upwards or downwards.
C1 VB detector
Model equivalent to the C1 detector but equipped with a circuit board to detect a low speed threshold.
C1 VB documentation in PDF format
DUO C1 detector
The centrifugal detector with two controlled thresholds enables precise detection of two pre-determined rotation speeds in rising or falling speed.
DUO C1 TACHY detector
Centrifugal detector equipped with a C1 and a tachy.
Documentation DUO C1 TACHY in PDF format
DUO R7+C1 detector
Type R7 detector and type C1 detector mounted on a single unit, allowing two applications to be combined in a single device.
TEST BENCH
The test bench is used to check our overspeed detectors (adjustment, calibration, etc.) by adapting the “factory” parameters: gradient up to nominal speed, then gradient up to release speed, horizontal or vertical positioning of the detector.
Documentation Test bench in PDF format
SERVAT TECHNOLOGIES
16 rue des Quilles,
77700, Chessy
Telephone: 0033.(0) 1 61 10 06 84
Fax: 0033.(0) 1 61 10 06 49
Email: contact@servat-technologies.com
Web: servat-technologies.com